More new product in the store

Recently added are dropped spindles, engine mounts and a few other goodies.

Like this, a bolt-in transmission crossmember for stock Model A frames. Allows you to use ’35 up style transmission mounts and a 48-52 Ford F1 brake and clutch pedal set. 

 

1955-1959 GM Dakota kits very soon. AND MORE!

Been working on the design for the newest kit to our line. The 1955-1959 GM Truck Dakota kit. We will have this ready by the end of September in two forms. Our standard kit that accepts the stock ’87-’96 Dodge Dakota componentry and this will be our first venture into a tube control arm and coil over front end! Yes, you read that right we are going to offer tube control arms very soon. I have been working on the design and the fixturing to get these to a reasonable cost. So look for an official release of the newest kits very soon.

We have also been working on engine mounts and bolt on anti-roll bar mounts. I have some almost ready to go for Ford and Chevy engines in the 35-56 F100 kits. I need to check fitment on the others before we release them.

 

 

New information regarding springs and brakes

I do my best to keep up with information on all of our products. I was recently informed that the earlier 1973-1982 Dodge D series rotors for the 3000 pound front axle take a different bearing and are not compatible with the Dakota spindles. I made a quick note on the D-series caliper bracket selection about this change and will soon update all of the information to reflect the correct interchanges.

This morning however, was a question about springs for the Dakota IFS kits with 302 Fords. This is a work in progress and as I gather more information about the spring selections I will add it to the list to help you guys get the most out of your front end. This new information about the spring selection is in the Dakota Tech section.

New product: D-series Caliper Brackets

We have started offering the caliper brackets that allow you to use the Wilwood D52 Dual Piston caliper bracket and the larger rotor from the ’73-’93 Full size trucks on your Dodge Dakota based front end. Have a look CLICK HERE

New kits on the horizion

I have frames for 1953-56 Ford F100 and 1955-59 GM trucks sand blasted and ready for prototyping. Stay tuned here and on our Facebook page for updates.