Posted on Leave a comment

Headway on the new generation of kits. 65-66 F100

Right Frame rail A
After squaring and leveling the donor frame from Bill Wilson, I set a Datum at the original Axle centerline. Then Taking careful measurements I can construct a representation in Alibre’.
1965 F100 Right Side Rail B
Added the rear half of the frame from previous. Also changed the way the bumpout for the core support works. Not technically correct but works with my software.
1965 F100 Right Side Rail C
Locating all the critical holes needed for current and future projects.
65-66 Frame assembly A
Alibre’ 12 isn’t as sophisticated as it could have been. Doing a mirror of the Right frame rail wasn’t as easy as a command. I had to re-generate each sweep, boss, and cut the opposite way to generate the Left side rail.
65-66 Frame assembly B
Tried an approximation of the stock transmission crossmember. I may go back and re-draw it. Added the rear body mount crossmember and gussets as well as the forward crossmember for supporting the rear springs.
1030 6566 Crossmember B
Very similar to the 61-64 kits, this one requires a taller boxing plate and different locating holes. The longer boxing plates should solve the problem of the long and unsupported front frame section once the stock Twin-I-Beam crossmember has been removed.

1030 6566 Crossmember C1030 6566 Crossmember A

Leave a Reply